-13-
Setting Motor Open and
Close Speeds
The opening and closing speed can be varied in 5% steps
from 50% -100% to suit the site. This function is useful if
the gate is situated on an incline where gravity increases
closing speed. (Factory Default = 80% Open, 50% Close).
Note:
Close speed can only be modified if a Photo Electric
Safety Beam is fitted. See Setting Photo Beam
instruction below.
1.
Press MENU for 3 secs then SET to cycle though to
Open Speed
or
Close Speed
as required.
2.
Press MENU to cycle through from 80% down to 50%
in steps of 5%. Once 50% is reached the next press
of the MENU button will return to 100%.
3.
When desired speed percentage is reached press
SET to confirm or MODE to save and exit.
Setting Gate Leaf Time Delay
Note:
Only available in dual motor mode.
If required Motor 1 can be set to open 2 seconds before
and start to close a preset time after Motor 2.
(Factory Default = Off).
1.
Make sure the gate is in the fully open position.
2.
Press MENU for 3 secs then SET to cycle though to
Motor Delay
.
3.
Press MENU to choose
On
.
4.
Press SET to confirm. The display will show
Set
Time Delay
.
5.
Press PB or transmitter button 1. Motor 2 will start to close.
6.
When the gate leaf reaches the desired point where
you would like Motor 1 to commence closing press
button again.
7.
Motor 1 will start to close and this time delay will be
stored in memory.
Note:
If an error is made during this procedure (i.e.
unwanted delay time), press PB or transmitter
button while the gate is moving to cancel the time
delay and return the gate to the fully open position.
Setting Photo Beam Mode
Note:
A functioning photo electric safety must be installed
and Photo Beam Mode set to ON to enable auto-
close function. Power Save Mode must be set to
OFF see page 15.
Photo Beam Mode allows the gate to close once the
beam has been tripped and restored. Smart Openers
strongly recommend the installation of a PE safety beam
to protect persons and property (Factory Default = Off).
1.
Connect PE beam cable to controller terminal black
as per Fig. 27.
2.
Press MENU for 3 secs then SET to cycle though to
Photo Beam
.
3.
Press MENU to choose
On
.
4.
Press SET to confirm or MODE to save and exit.
Open Speed
80%
Close Speed
50%
Fig. 24
Fig. 25
Motor Delay
On
Fig. 26
LEARN
P/B
MODE
MENU
SET
M2 Open Limit
Com
M2 Close Limit
M1 Open Limit
Com
M1 Close Limit
Com
Photo Beam 2
Photo Beam 1
+24V
Lock +
Lock -
Fig. 27
Photo Beam
On
Fig. 28
Содержание Smart Slider
Страница 18: ... 18 Notes ...
Страница 19: ... 19 Notes ...
