SMA 10000TL, Руководство по эксплуатации

Страница: 47 / 74

8 Configuration
8.1 Configuration Procedure
Once you have commissioned the inverter, you may have to adjust various settings via the rotary
switches in the inverter or via a communication product. This section describes the procedure for
configuration and gives an overview of the steps you must perform in the prescribed order.
Procedure See
1. If the display language is not set correctly, adjust the set-
tings. Section 8.2, page 47
2. If you want to integrate the inverter into a Speedwire net-
work, connect the inverter to the network. Section 8.3, page 48
3. Integrate the inverter into the network. Section 8.4, page 49
4. To manage the PV system data or to set the inverter pa-
rameters, capture the inverter in a communication product. Manual of the communica-
tion product at www.SMA-
Solar.com
5. Change the system time and system password. Manual of the communica-
tion product at www.SMA-
Solar.com
6. If a residual-current device with a tripping threshold of
30 mA was specified and has been installed, set the trip-
ping threshold of the residual-current device. Section 8.7, page 51
7. If using the multifunction relay, ensure that the operating
mode is set correctly and adjust any further settings for the
operating mode as necessary. Section 8.8, page 51
8. For partially shaded PV modules and depending on the
given shading situation, you should set the interval at
which the inverter optimizes the MPP of the PV system. Section 8.9, page 52
8.2 Changing the Display Language
If the language for the country data set is not the language you want to use, you can change the
display language as follows:
Procedure:
1.
Danger to life due to high voltages
• Disconnect the inverter from all voltage sources and open the enclosure lid (see
Section 10, page 57).
8 Configuration SMA Solar Technology AG
Operating Manual 47 STP5-12TL-20-BE-en-15