Universal Live Timing Box Rev 2.0 User manual
The buttons that can be found in the
"Telemetry
" page (figure 41):
•
Reset all
:
erase the data displayed in the following fields:
Lap time, Lap number, Sector
time, Sector number, Best time and Best lap
;
•
Reset best time:
erase the best time recorded until that moment and the corresponding lap
number;
•
STOP TELEMETRY: clicking this button stops the live telemetry function and gives the
user the possibility to access directly the
postprocessing
function, on the data that was
previously saved on file. See paragraph 2.2.1.5 for an explanation of postprocessing.
18.2.1.7 Postprocessing function
The
"Postprocessing"
is an analysis of the saved data, as shown in figure 43 . The screen is divided
in two sections, DRIVER1 and DRIVER2, as it possible to load the data of two different drivers or
of two different runs
of the same driver in order to compare them. It is necessary to select the file to
be analysed, using the
Browse "Path_file1"
and/or
"Path_file2"
button. Among the available files it
is necessary to choose the one ending with "_t.txt". Once the selection has been done, the relative
times are reported in the table to the side. The worst time is highlighted in red, the best time in
green. Moreover, if telemetry data are present, too, the
Live Timing Box PC Interface
application
enables a second page,
"Postprocessing 2"
(figure 44), in which the telemetry data can be
visualized, by selecting the desired lap number.
51
Figure 42:
PC Chrono page.
