Skyworth SKW-T21, Руководство пользователя

Страница: 26 / 30

Please, enter your PIN code to access this menu and press
OK
to start formatting.
Press  to leave this menu.
NOTE:
After performing the Safely Remove function, the USB device is no longer
accessible by your receiver. To gain access to you’re the storage device
again, re-insert it or switch the receiver to standby and on again.
WARNING:
Formatting will permanently delete ALL data stored on the connected
device. Please make a backup copy of all data you wish to keep before
entering the
Format menu. SKYWORTH cannot be held responsible for loss
of data from USB devices used with this receiver.
NOTE:
It is possible to use USB storage devices already formatted in NTFS.
*This user manual describes the full functionality including the recording function and may not be applicable if the
software for recording via USB has not yet been installed (available in our web shop: www.strong.tv).
7.5 Network
This menu consists of the following submenus: RSS , Weather and IP Settings . First connect a CAT5E
(or higher quality) cable to the RJ-45 (ETHERNET) port of your receiver and ensure the other end
is connected to the internet accordingly. If there are questions or problems with the internet
connection, we recommend you to check details via the support or helpline of your internet provider.
Before you start to use the Internet functions please check the setup of the Internet connection
via
IP Settings menu and confirm SET with
OK
. Usually the Internet connection should now been
established without any problem and ready to use. A message will inform you if the connection has
been setup successfully or not, use
OK
to confirm and press
9
to leave this menu.
Inside the menu use pq to highlight the submenu of choice and press
OK
to enter. Press  to quit
or
9
to go one step back.
7.5.1 IP Settings
This menu allows you to setup or check the Internet connection. The default selection is DHCP set to
On
. Normally the setup is done automatically by this. To test if the Internet connection works, select
the item SET and press
OK
. If successful, a pop-up message box will show up and you can start using
it. If not successful, then check your cable or router. Alternatively set DHCP to Off . Then manually
enter your IP, Gateway and DNS values by using the
0 ~ 9
buttons. Select after entering these values
the item SET and press
OK
to store and to check.
7.5.2 RSS Feed (Really Simple Syndication)
This menu allows you to choose an RSS news link to read the latest news from different sources.
22