Skyworth SKW-T20, Руководство пользователя

Страница: 22 / 24

18
WaRning:
After an update the receiver restarts automatically on the last watched
channel. During the upgrade process NEVER disconnect the receiver from
the mains respectively from the antenna cable or switch off the power!
Doing so might damage your receiver and will void warranty!
8.0 TROubLesHOOTing
There may be various reasons for abnormal operation of the receiver. Check the receiver according to
the procedures shown below. If the receiver does not work properly after checking it, please contact
your dealer or the local Service Hotline or send email to our Support via www.strong.tv. Do NOT try to
open or disassemble the receiver. It may cause a dangerous situation and warranty will be void.
problem possible cause What to do
LED indicator is not lit The mains lead is unplugged Check the mains plug
No signal found The antenna is disconnected
The antenna is damaged/misaligned
Out of digital signal area
Active antenna requires to switch
ON the antenna power/external
power
Check the lead of the antenna
Check the antenna
Check with your dealer
Switch the antenna power of the
receiver ON/connect external power
No picture or sound on
TV or amplifier
HDMI or SCART is not selected on
your TV or amplifier or the unit is
set to higher resolution as the TV
supports.
TV/amplifier is not switched on
Switch to correct TV/amplifier input
Select lower resolution on receiver
Switch TV/amplifier on.
Check if S/PDIF connection is used.
Scrambled channel
message Channel is scrambled Check if you have the rights to
watch this channel
No response to the
remote control
The receiver is off
The remote control is not aimed
correctly
The front panel is obstructed
The batteries of the remote control
are exhausted
Plug in and turn on the plug
Aim the remote control at the front
panel
Avoid obstructions
Replace the batteries of the remote
control
Forgotten Parental
Control PIN code
Forgotten channel lock
code
Default PIN is
0000
Contact your local Service Hotline
or send an email to our Support via
www.strong.tv
After moving the receiver
to another room/area
you are no longer able to
receive digital reception
The antenna signals are too weak
The signal strength/quality might be
less than before, if using an indoor
antenna
Press
infO
on the remote control to
check the signal bars on screen and
adjust the antenna for (maximum)
reception. Alternatively, do a rescan
of the channels.
When using an active antenna,
check if the antenna power setting
is
On
Try using an outdoor antenna