16
been made and responded.
4.1.3 Advices
* In case of power shortage, immediately switch the machine o
ff
.
* Use recommended or equivalent lubricants, oils or greases.
* Avoid mechanical shocks, once they may cause damages or bad func
ti
oning.
* Avoid water, dirt or dust contact to the mechanical and electrical components of the
machine.
* DO NOT change the standard characteris
ti
cs of the machine.
* DO NOT remove, tear o
ff
or maculate any safety or iden
ti
fi
ca
ti
on labels stuck on the
machine. If any labels have been removed or are no longer legible, contact your nearest
dealer for replacement.
4.2 Safety Procedures and Notes before Switching the Machine ON
IMPORTANT
Carefully read ALL INSTRUCTIONS of this manual before turning the machine ON.
Be sure to well understand all the informa
ti
on contained in this manual. If you
have any ques
ti
on contact your supervisor or your nearest Dealer.
4.2.1 Danger
An electric cable or electric wire with damaged jacket or bad insula
ti
on might cause
electrical shocks as well as electrical leak. Before use, check the condi
ti
ons of all wires
and cables.
4.2.2 Advices
Be sure to well understand all the informa
ti
on contained in this manual. Every opera
ti
on
func
ti
on or procedure has to be thoroughly clear.
Before using any commands (switch, bu
tt
ons, lever), be sure it is the correct one. In case
of doubt, consult this manual.
4.2.3 Precau
ti
ons
The electric cable has to be compa
ti
ble with the power required by the machine.
Cables touching the
fl
oor or close to the machine need to be protected against short
9
2 Installa
ti
on and Pre Opera
ti
on
2.1Installa
ti
on
2.1.1 Placing
Place the equipment on a dry, stable and level surface having a preferen
ti
al 850 mm height
above the
fl
oor.
850 mm
PICTURE 02
IMPORTANT
Do not operate the equipment when it is placed near a table edge (PICTURE 02).
