Fit 2 L-shape servo brackets to 2 x JR DS8511.
The 2 servo’s must be mounted back to back
with servo horn closets to TE of wing.
Secure servo horns and centre servo’s with TX.
Secure 2 x extension wires. Use safety clips on joint.
Feed wire through ribs.
Secure servo’s to wing. Use 8 servo screws.
Draw a line perpendicular to hinge line.
Use masking tape to mask off area around control
horns. This will help with inserting glue in slots.
Mark location of horns. Make sure pivot point is directly
above hinge line.
Use Dremel to cut slot for control horns.
Use 30 minute epoxy to glue control horns
After epoxy cured, insert pushrods.
Cut slots in servo cover to clear servo horns.
Secure servo covers with 6 , 1mm set screws.
P-12
Assembly & Operation Manual
Photo 14
Photo 15
Photo 16
Photo 17
Photo 18
