Assembly & Operation Manual
Slide fin in position and secure with bolt.
Fit pushrod.
Check operation of control surface and adjust rudder
pushrod for centre.
Fin can be removed for transport via hole in fuselage.
VENTRAL FINS
NOTE:
Make sure to have some sort of protective foam
on the work bench. This will protect the paint surface
from unwanted dents. Mark
√ each step.
Dril 4 2mm pilot holes for ventral fins
Use aeropoxy and glue 2.5mm steel pins in position.
Mark locations for pins onto ventral fins.
Drill 4 2mm pilot holes into ventral fins.
Trial fit fins. Note the fins are shaped to fit fuselage. Make sure it aligns with the
panel line drawn on fuselage.
Mask off area both sides of each ventral fin. This will help not to get glue onto un-
wanted areas.
When happy use silicon glue and glue fins in position.
Align fins with turbine hatch. Make sure both fins sit at
same angle. (Note: If model unpainted do this after
painting)
P-16
Photo 34
Photo 35
Photo 33
