6
PrOgrAmmINg FOr ZONE OPErATION
In the above table, both the Family Room Ceiling Light and Family Room Floor
Light are in zone 1. You need to assign the zone 1 signal to both receivers in these
2 locations.
That means for Light 1 receiver in the example, you need to program the following
signals:
- Button 1 to Light 1 based on Programming for Individual Operation
- Zone 1 Command to Light 1 based on Programming Zone Operation
For Light 2 in the example, you need to program the following signals:
- Button 2 to Light 2 based on Programming for Individual Operation
- Zone 1 Command to Light 2 based on Programming Zone Operation
To assign a zone to a receiver module, follow the instructions below:
1. Put the receiver module that you plan to program into programming mode.
Refer to the User’s Instructions of that receiver module.
2. When in standby mode, the LCD display will show the current time. Press
the [PROG] button 3 times to enter the Zone Programming mode. The
Signal icon [ ] and ZONE icon and red LED stay on for 15 seconds.
3. Press the zone number button, i.e. [1] for zone 1. Red LED light will flash then
go off. The signal icon will disappear indicating the “Learn” code has been
sent.
3. Once the receiver module is in programming mode, press the button [1 – 9]
on the remote that you plan to use to transmit the “Learn” code. Red LED
will flash and then off. The signal icon will disappear indicating the “Learn”
code is sent.
4. Once the remote is programmed, the receiver module will quit from
programming mode and the programmed remote is ready to be used now.
Signal icon
Zone icon
Содержание TD-318
Страница 1: ...Model TD 318 User s Instructions LCD Deluxe Remote ...
Страница 15: ...14 ...
Страница 16: ...15 101Z946 rev 4 DEC 2012 ...