Skyjack SJIII 4740, Руководство по эксплуатации

Страница: 14 / 94

It is the responsibility of the operator to read, completely understand and follow all instructions and warnings
contained in this operating manual and on the aerial platform.
F
AMILIARIZA
TION
2.2 Component Identification
The following descriptions are for identification,
explanation and locating purposes only.
2.2-1 Main Power Disconnect Switch
This switch is located at the rear of the base.
1
Figure 2-1. Main Power Disconnect Switch
1. Main Power Disconnect Switch - This switch,
when in “ ” off position, disconnects power to
all circuits. Switch must be in “ ” on position to
operate any circuit. Turn switch “
” off when
transporting MEWP.
2.2-2 Tilt Alarm
The MEWP is equipped with a device which senses
when the MEWP is out of level in any direction. When
activated, it disables drive and lift functions of the MEWP
and an alarm produces an audible sound accompanied
by the amber light (if equipped).
WARNING
I f t h e t i l t a l a r m s o u n d s a n d t h e
platform does not, or only partially
raises, immediately lower the platform
completely and ensure that the MEWP is
on a firm level surface.
2.2-3 Base Control Console
This control console is located at the rear of the base.
It contains the following controls:
1
2
3
Figure 2-2. Base Control Console
1. Lower/Neutral/Raise Switch - This switch
controls “ ” raising or “ ” lowering of
platform.
2. Off/Platform/Base Key Switch - This three-way
switch allows the operator to turn “ ” off power
to MEWP or to activate either “ ” platform or
“ ” base controls.
3. Emergency Stop Button - This button “ ”,
when depressed, disconnects power to the control
circuit.
Page 14
SJIII 4740
Control Functions Section 2 - Familiarization