Skyjack 7127, Руководство по эксплуатации

Страница: 38 / 85

Mid Size & Full Size RT’s
Engine Powered February 2008
SKYJACK, Page 39
Function Tests Section 2 - Operation
Test Brakes •
wARNiNG
Brakes will engage instantly when you
release the controller handle, causing
aerial platform to stop immediately.
1. Ensure path of intended motion is clear.
2. Activate and hold “ ” enable trigger
switch.
3. Drive aerial platform “ ” forward. Test
brake by releasing controller handle.
Result: Aerial platform should come to
a stop. If aerial platform pulls to one side
while stopping, do not operate aerial
platform until brake adjustments have
been checked.
4. Drive aerial platform “ ” forward. Test
brake again by releasing “ ” enable
trigger switch only.
Result: Aerial platform should come to an
instant and abrupt stop. If aerial platform
does not stop immediately, or if aerial
platform pulls to one side while stopping,
do not operate aerial platform until brake
adjustments have been checked.
Test Horn •
1. Push “ ” horn pushbutton.
Result: Horn should sound.
Test Tilt Sensor •
wARNiNG
Be aware of overhead obstructions
or other possible hazards around the
aerial platform when lifting.
wARNiNG
Ensure that there are no personnel
or obstructions in the path of travel,
including blind spots.
1. Move the aerial platform on to a slope not
greater than 10°.
2. Use the ladder to dismount from
platform.
3. On base control console, slowly raise the
platform.
Result: When platform reaches an
appropriate height, a warning signal
should sound and platform stop raising
as lift and drive controls should be
disabled.
Torque Switch
Engine Start
Pushbutton
Horn
Pushbutton
Glow Plug
Pushbutton
Lift Enable
Pushbutton
Emergency Stop
Button
Operation Light
Off/Lift/Drive Key
Switch
High/Low Torque
Switch
Raise/Off/Lower
Switch
Low/High Throttle
Switch
Drive/Steer Controller
Rocker Switch
Enable Trigger
Switch