10
OPERATOR’S GLOSSARY OF TERMS
•
Bevel Cut:
A cutting operation made with
the blade at any angle other than 90° to
the miter table.
•
Blade Flange:
A ring or collar on a spindle
or arbor that permits other objects, such
as a blade, to be attached to it.
•
Compound Miter Cut:
A cut made using
both a miter angle and a bevel angle at
the same time.
•
Crosscut:
A cutting operation made
across the grain of the workpiece.
•
Kerf:
The material removed by the blade
in a through cut, or the slot produced by
the blade in a non-through or partial cut.
•
Kickback:
A hazard that can occur when
the blade binds or stalls, throwing the
work piece back toward the operator.
•
Miter Cut:
A cutting operation made with
the blade at any angle other than 90° to
the fence
•
Nested Crown:
Positioning the crown
workpiece at an angle between the fence
and the table to eliminate the need to
make a bevel cut.
•
No-Hands Zone:
The area between the
marked lines on the left and right side of
the base. This zone is identified by the
No-Hands Zone symbols inside the lines
marked on the base.
•
Non-through Cut:
Any cutting operation
w h e re t h e b l a d e d o e s n o t e x t e n d
completely through the thickness of the
workpiece.
•
Revolutions Per Minute (RPM):
The
number of turns completed by a spinning
object in one minute.
•
Saw Blade Path:
The area over, under,
behind, or in front of the blade, as it
applies to the work piece; the area that
will be or has been cut by the blade.
•
Spindle:
The revolving shaft on which a
blade or cutting tool is mounted.
•
Workpiece or Material:
The item on which
the cutting operation is performed. The
surfaces of a workpiece are commonly
referred to as faces, ends, and edges.
Содержание SPT88
Страница 119: ...119 Notes Remarques Notas...
