Ski-Doo Formula S 1998, Руководство по ремонту, Страница: 265 / 338

Section 07 REAR SUSPENSION
Subsection 03 (SC-10 SPORT AND TOURING SUSPENSION)
07-03-4
Close and lock bar. Adjust handle horizontal by
changing position of clevis pin.
Push down on handle until il locks. Remove spring
stopper and cap then release handle.
At installation, cap opening must be 180° from
spring stopper opening.
1. Spring stopper opening
2. Cap opening
20, Stopper Strap
Inspect strap for wear or cracks, bolt and nut for
tightness. If loose, inspect hole for deformation.
Replace as required. Make sure it is attached
through the 2
nd hole from the end. Torque nut to
11 N•m (97 lbf• in ).
1. 1 st hole
2. 2 nd hole
A. 11 N•m (97 lbf• in )
INSPECTION
Shock Absorber
Refer to SUSPENSION AND SKI SYSTEM 08-03
then look for
Shock Inspection .
17, Slider Shoe
Measure slider shoes from the bottom to the 0.5
mm (.020 in) radius as shown on the next photo.
Minimum thickness must be 2 mm (.080 in).
TYPICAL
1. Slider shoe
2. Molding line (this line is not the wear limit)
A. Wear limit measurement (must be at least 2 mm (.080 in))
Replace slider shoes when wear limit is reached.
INSTALLATION
Do not install rear spring yet. Install assembled
suspension into track with front portion first.
Insert rear portion of suspension into track.
2,3,4,5,6, Spring, Washer, Idler Wheel,
Spacer and Screw
On each side, install rear spring, washer, idler
wheel, spacer then bolt that axle to tunnel.
A03F12A
1
2
A03F0QA
A
1
2
-
CAUTION
Slider shoes must always be replaced in
pairs.
A01F2MA
1
2
A