Ski-Doo Formula S 1998, Руководство по ремонту

Страница: 97 / 338

Section 04 ENGINE
Subsection 03 (377, 443 AND 503 ENGINE TYPES)
04-03-12
For bearing lubrication purpose, a gap of 1.0 mm
(.040 in) must be maintained between seals and
bearings.
When installing plain oil seals (seal without locat-
ing ring or without spacing legs), ensure to main-
tain 1.0 mm (.040 in) gap.
1. Bearing
2. Feeler gauge
3. Plain oil seal
A. 1 mm (.040 in)
Crankcase halves nos. 1 and 9 are factory
matched and therefore, are not interchangeable
as single halves.
Prior to joining of crankcase halves, spray some
new injection oil (or equivalent) on all moving
parts of the crankshaft. Spray Primer N (P/N 413
7081 00) on one of mating surfaces. Let it dry for
10 to 20 minutes.
Apply paste gasket (P/N 413 7027 00) no. 5 on the
other mating surface.
NOTE: Primer N allows Loctite 515 to fully cure
on aluminum surfaces. It increases filling capacity
and reduce curing time.
Position the crankcase halves together and tight-
en bolts by hand then install and tighten armature
plate on magneto side to correctly align the crank-
case halves.
503 Engine Type
Torque screws nos. 6, 7, 8 and 11 to 10 N•m (89
lbf• in ) then to 22 N•m (16 lbf•ft) following illus-
trated sequence.
377 and 443 Engines
Torque screws to proper torque in the following
sequence.
A. 10 N • m (89 lbf • in )
All the other screws are torqued to 21 N•m (15 lbf•ft)
All Engines
To install magneto, refer to CDI MAGNETO 04-05.
A17C07A
1 A
2
3
11 5 3 1 7 9 13
14 10 6 4 2 8 12
A17C08A
10
8 14
4
2
12
6
5 11
3 1
13
7 9
A
A
A09C05A