Ski-Doo Formula S 1998, Руководство по ремонту, Страница: 217 / 338

Section 06 ELECTRICAL
Subsection 03 (IGNITION TIMING)
06-03-7
To check the ignition timing, refer to illustration
and proceed as follows:
NOTE: Engine should be cold when checking tim-
ing. Do not idle engine for more than 20 seconds
and make checks quickly.
1. Connect the timing light pick-up to a spark plug
cable and the power connections to the battery.
NOTE: To avoid an incorrect reading due to paral-
lax, view the magneto flywheel and the crankcase
timing marks in a straight line.
2. Start the engine and raise the engine speed at
least to 2000 RPM while observing the timing
marks, refer to illustration. The magneto fly-
wheel mark scribed previously and the crank-
case arrow should be perfectly aligned. If the
marks do not align, a faulty trigger coil (check
proper grounding of coil) or a faulty CDI module
could be the cause: substitute one part at a
time and recheck timing marks (check connec-
tors condition prior to substituting any part).
NOTE: Ignition timing may be verified when en-
gine speed is anywhere within 2000-6000 RPM.
S-SERIES
1. Timing light pick-up on MAG side
2. Crankcase arrow
3. Magneto flywheel mark
3. Install parts which were removed.
;
WARNING
Place ski tips against a wall, raise rear of ve-
hicle on a stand, so that track does not con-
tact the ground. Do not allow anyone in front
of or behind the vehicle while engine is run-
ning. Keep clear of track and do not wear
loose clothing which can get caught in mov-
ing parts.
A03E1EA
2
3
1