Ski-Doo Formula S 1998, Руководство по ремонту, Страница: 258 / 338

Section 07 REAR SUSPENSION
Subsection 02 (TORQUE REACTION SUSPENSION)
07-02-3
1. Flat head punch
2. Support
3. Runner
4. Metal block
NOTE: Rivets can be substituted with 3/16 in x
3/4 in long screws and flanged elastic stop nuts.
Always position screw head outside the assem-
bly.
INSPECTION
Shock Absorber
Refer to SUSPENSION AND SKI SYSTEM 08-03
for shock inspection.
11, Slider Shoe
Measure slider shoes from the bottom to the
0.5 mm (.020 in) radius as shown on the next pho-
to.
Minimum thickness must be 2 mm (.080 in).
TYPICAL
1. Slider shoe
2. Molding line (this line is not the wear limit)
A. Wear measurement (must be at least 2 mm (.080 in))
Replace slider shoes when wear limit is reached.
INSTALLATION
Release rear spring tension then install assem-
bled suspension into track with front portion first.
Insert rear portion of suspension into track.
Bolt suspension to tunnel.
Pry rear spring end onto cam.
1. Spring end
A07F02A
1
3
4
2
-
CAUTION
Slider shoes must always be replaced in
pairs.
A01F2MA
1
2
A
A05F0JA
1