IndustrialPro™ and MobilityPro™ Gateway
User's Guide
Copyright © 2010 Sixnet LLC. All rights reserved.
21
1.11
– November 2, 2011
1.3.8.2
USB Device Port
This is a USB 2.0 Device interface on a Type B (BT-5x00v2) or Mini B (BT-6xxx) connector. It offers Ethernet-over-USB
functionality using the RNDIS driver for Windows XP and Windows Vista Operating systems only. The BlueTree RNDIS
driver must be installed before the USB interface can be used. The driver is automatically installed with BlueTree Device
Manager or you can obtain the driver at
1.3.8.3
Serial Port (DB9)
The modem’s serial port is an RS232 DCE, compliant with EIA-232 standard. The connector used is DB9 female and is
shown in the illustration below.
Figure 3 – Serial connector (looking at back of modem)
For further serial wiring information, refer to the
Hardware Installation
section.
1.3.9
RESET button functions
Table 9 – Reset button functions
Mode
Pattern
Description
Hard reset
Press and hold for less than
3 seconds
Standard reboot
Factory restore
Press and hold between 3
and 10 seconds
RS232 LED flashes quickly
Overwrites user configuration with
the default factory settings
FW upgrade
Press and hold between 10
and 15 seconds
WAN LED flashes quickly
Puts the modem in advanced
firmware upgrade mode by restarting
the modem and running the
bootloader only. Do not use this
mode unless instructed to by
BlueTree Technical Support.
USB pass-through
Press and hold for longer
than 15 seconds
Signal LED flashes quickly
Puts the modem in main pass-
through mode to the RF module,
allowing CCT provisioning and PST
support. Do not use this mode unless
instructed to by BlueTree Technical
Support.
