sitrex SR 320/8, Использование и обслуживание

Страница: 23 / 36

23
8) MAINTENANCE DIRECTIONS
All cleaning, lubrication and maintenance operations must be carried out with the machine
disconnected from the tractor. In an emergency with the machine still connected to the tractor, switch
off the engine, apply the parking brake, disengage the power takeoff and remove the ignition key
from the instrument panel.
Regular, correct maintenance and proper operation are the basic prerequisites for the long-term
efficiency and safe operation of the machine.
Pay special attention to all instructions given on signs located on the machine.
All maintenance should be carried out in an area having the proper equipment readily available and in
good condition. This area must always be kept clean and dry and must, have enough surrounding
space to facilitate operations.
Any work must be carried out by trained personnel. Contact the dealer nearest to you.
Respect the warnings and procedures for maintenance and technical assistance given in this manual.
Do not use petrol, solvents or other flammable liquids as deterrents.
Use commercial non-flammable and non-toxic solvents, authorized by competent bodies.
Do not use compressed air or water at high pressure to clean the machine. If this is unavoidable,
then wear goggles with side protection and limit the pressure as much as possible. When the work is
finished, and with the machine disconnected from the tractor, inspect and check the machine
completely.
REPAIR INSTRUCTIONS
Any repair work must be carried out with the machine at rest and disconnected from the tractor.
Do not carry out welding without authorization and instructions from the manufacturers.
Disconnect the machine from the tractor before any welding work in order not to damage the battery.
Always use a protective mask, goggles and gloves when welding, sanding or grinding or when using
a hammer or drill.
Always work on the machine out of doors. If you have to operate the machine when connected to the
tractor in an enclosed area (for example when testing after repair and/or maintenance), ensure that
there is sufficient ventilation so as to prevent noxious exhaust gases accumulating.
In order to acquire the necessary control and to operate in safety, practise various manoeuvres by
simulating those required in the workplace with the help of an experienced person.
If you activate the machine while it is raised from the ground, make sure there is nobody standing
nearby or in a dangerous position.
LAYING UP FOR EXTENDED PERIODS
At the end of the season, or when an extended period of inactivity is envisaged, it is advisable to:
a) Clean the machine following instructions and allow it to dry.
b) Check it carefully and replace any damaged or worn parts.
c) Thoroughly tighten all screws and bolts.
d) Grease the machine thoroughly and then cover it completely and lay it up in a dry place.
It is to the user's advantage to carry out these operations carefully. In this way, he will have a
machine in perfect condition when work is restarted.
On recommencing work, repeat all the proper checks so as to be certain of working in conditions of
maximum safety.
MAINTENANCE POINTS