sitrex SR 320/8, Использование и обслуживание

Страница: 22 / 36

22
TRANSPORT
If the machine is used on the road, make sure it complies with traffic regulations in
your country; use regulation lights and comply with the safety regulations.
Preparation for transport
Loosen the swath-shaper plate carrier and reinsert it until the safety hook is released,
then tighten the lock screw once again.
Turn the protection frames facing upwards one at a time and use hook 23 to fasten
them, insert safety clamp 24 into the special slot (see diagram).
Remove tine carrier arms 44 from their slots and take out lock clamps 43, insert the
arms into the special slots on side frame 1; the arms should be inserted with the tines
facing into the machine. Clamps 43 should be placed into the holes on the rotor arms.
If the machine does not have to travel far, there is no need to remove all the tine carrier
arms. The 3-4 central front and rear arms can be left in position, because when the
protection frames are raised, lock 37 (see Fig.14 pg.13)takes up position between the
two tine carriers and limits the possibility of rotation. However, the rear arms must be
removed if the machine is taken on the road.
Before raising the machine make sure that the rear cab window on the tractor is closed. The
protection frames on the rake could cause damage..