sitrex MK14 MY15, Сборка

Страница: 29 / 38

29
31) DANGER (see drawing on preceding page)
Connect coupling 1 to cylinders A using washers 2 and bolts 3. Apply nipple 4 to
coupling 1. Apply washer 2 and valve 5 to nipple 4. Apply washer 2 and nipple 6 to
valve 5. Insert hoses 7 in the guide rings B so that the one end of the hoses goes to the
center of the machine and the other end near the nipples screwed onto valves 5. Now
connect hoses 7 to nipples 6 without fastening completely. Secure the hoses 7 using
collars 8 and screws 9. Join the ends of the hoses 7 to the T coupling at the center of the
machine without fastening completely.
Bring the female end of hose 11 near to the T coupling 10 and extend it along drawbar
C. Connect the female end of hose 11 to the T coupling 10 without fastening
completely. Note: Before fully fastening all the hoses, make sure that the line of the
hose from one end to the other is not twisted and/or does not have sharp bends or kinks
that cause it to be crushed or to have an unpleasant appearance.
Now secure hose 11 using collars 8 and screws 9. Hose 11 will also be in the following
steps.
In this step, you will use:
Item 1: 2 couplings eye 3/8” female 3/8”
Item 2: 8 washers ø3/8”
Item 3: 2 screw-type couplings 3/8”
Item 4: 2 nipples 3/8”-3/8”
Item 5: 2 valves 3/8”
Item 6: 2 nipples 3/8”-3/4” JIC 37°
Item 7: 2 hoses, 3/8”, length 1840 mm (3/8”x72.44”)
Item 8: 8 collars ø18 (ø0.71”)
Item 9: 8 cheese head screws M6x25 (0.24”x1”)
Item 10: 1 male T coupling, 3/8” JIC 37°
Item 11: 1 hose, 3/8”, length 6700mm (3/8”x263.78”)