sitrex MK14 MY15, Сборка

Страница: 2 / 38

2
Assembly Instructions
Examples of general measurements for identifying assembly accessories according to
type.
To make it easier to identify the assembly accessories (nuts, bolts, washers, pins, etc.)
on the basis of the general dimensions and the type, we provide a diagram that shows
you the accessory parts to which the measurements refer as given in the various steps
of assembly.
The drawings are schematic and do not always faithfully reproduce the accessories,
but they will be of help in identifying them correctly.
Note: the accurate measurements are those given in mm; those given in inches are
rounded off, and for threads the size in inches is given only as an aid, as it does not
accurately describe the thread.
You can see the following examples:
Box “A”: shows springs that are will be identified by the wire diameter, the outside
diameter and the length, thus in this case ø3-ø18x110 (ø0.12”-ø0.71”x4.33”)
Box “B”: shows handles, spring pins, split pins, etc. that will be identified by the
diameter of the shank and the length, thus in this case ø8 x 50 (ø0.12” x 1.97”)
Box “C”: shows shims, bushings, spacers and washers in general that will be
identified by the inside diameter, the outside diameter and the length and/or the
thickness (for washers), thus in this case ø18-ø35 x 30 (ø0.71”-ø1.38” x 1.18”) or for
washers ø18-ø35 x 3 (ø0.71”-ø1.38” x 0.12”).
Box “D”: shows retaining rings for internal housings/bores that will be identified by
the diameter of the bore preceded by an I, thus in this case I35-1.38”, and for external
shafts that will be identified by the diameter of the pin preceded by an E, thus in this
case E35-1.38”.
Box “E”: shows pins, bolts, etc. that will be identified by the outside diameter (thread
diameter for bolts) and the length, thus in this case ø20 x 70 (ø0.78” x 2.76”) or for
bolts M20 x 70 (0.78” x 2.76”).
Box “F”: shows nuts and grease nipples that will be identified by the thread diameter,
thus in this case M10 (0.39”).
Box “G”: shows R-clips that will be identified by the diameter of the shank, thus in
this case ø3 (ø0.12”).