Rear - Network Camera
Antenna
Attach the supplied antenna here. The antenna is adjustable; best
results are usually obtained with the antenna positioned vertically.
SPKR out
If required, an external speaker can be plugged in here.
Power Input
Connect the supplied 5V power adapter here. Do not use other
power adapters; doing so may damage the camera.
LAN port
Use a standard LAN cable to connect your Network Camera to a
10/100BaseT hub or switch.
Note:
•
Plugging in the LAN cable will disable the Wireless interface.
Only 1 interface can be active at any time.
•
The LAN cable should only be connected or disconnected when
the camera is powered OFF. Attaching or detaching the LAN
cable while the camera is powered on does NOT switch the
interface between wired and wireless.
Reset Button
This button is recessed; you need a pin or paper clip can be used to
depress it. It can be activated at any time the camera is in the
"ready" mode.
•
Reset to manufacturer default value and reboot
. When
pressed and held over 10 seconds, the settings of Network
Camera will be set to their default values.
Note
:
After this procedure is completed, the
Power
LED will blink three
times to confirm that the reset was completed successfully.