Flight Simulators Solutions
SC
1.7
SC-MB Ethernet Configuration
User Manual
SC-MAN-SCE-E-17-0003
15 / 23
User Manual - SC-MB Configuration - Rev1.7.docx
If for whatever reason, you believe it would be better to restart the
configuration from scratch, you have two options. The first is to press the
button RESTORE DEFAULT VALUES on the CONFIG PAGE.
You could also open the back-metal cover of the Motherboard and press the
physical RESET button for at least 10 seconds. For this to have any effect, the
SC-MB must be connected to a power supply.
Both of these methods erase the EEPROM (Electrically Erasable Programmable
Read-Only Memory).
6.2.3
DAUGHTER BOARD CONFIG
In this field, we must indicate the Daughters Boards which are going to be connected to the Mother Board.
We can select as many as we wish, even if they are not connected, however this will slow down data
processing speed. We advise you select only the Daughters Boards which are connected to the Mother Board.
The CONFIG PAGE allows the activation of a total of 2 Inputs
Daughters Boards, 2 of Outputs, 1 of Displays, 1 of Servos and 1
ADC (pots). These are considered sufficient to manage most
systems.
Pressing SAVE DAUGHTER CONFIG is enough for the information to
be stored. It isn’t necessary to restart the browser for the daughter
configuration to be saved.
You will not need to revisit the CONFIG PAGE unless you want to
make a specific change to the configuration. For example, if you
purchase another daughter board you wish to connect.
Note: if the CONFIG PAGE has difficult loading throughout the configuration, don’t worry, it is slow because of the
internet protocol. If the CONFIG PAGE is too slow or fails to load, try reloading the CONFIG PAGE on a new browser.
You can also remove the power supply and start the configuration from the beginning.
The following table shows the daughter boards that must be active for each module.
MODULE
MCP-EFIS
MIP
Pedestal FWD
AFT
MAX Pedestal
SC-MDODB OUTPUTS1
ON
*
ON
ON
SC-MDODB OUTPUTS2
SC-MDIDB INPUT1
ON
ON
ON
ON
SC-MDIDB INPUT2
ON
*
ON
ON
SC-MSDB SERVOS
ON
ON
ON
ON
ON
SC-MDDB DISPLAYS1
ON
ON
SC-MDDB DISPLAYS2
ON
ON
SC-MAIDB ADCS
