Flight Simulators Solutions
SC
1.7
SC-MB Ethernet Configuration
User Manual
SC-MAN-SCE-E-17-0003
12 / 23
User Manual - SC-MB Configuration - Rev1.7.docx
1.
It will now be possible for the Control Computer and the Motherboard to communicate, and now we
must configure the board.
This provisional change in the IP address does not pose a problem for the configuration of the rest of the
modules that the user has done previously, because once we access the configuration page of this
equipment, it will be possible to restore the previous IP addresses as well as give a new IP address to the
Mother Board with the Network ID that the user has used in the network.
6.2
CONFIGURATION OF THE MOTHERBOARD
The next step is to make sure that the ports and IP addresses are compatible and that the computer and the
Motherboard can communicate. There is a
CONFIG PAGE
where we can do all these operations. To access it,
open your usual internet browser (internet explorer, chrome, etc.) and type in the IP Address of the
Motherboard on the address bar. In this example, a default Motherboard which is not from a Plug&Fly
Module.
http://192.168.1.150/
(How do I know this? See 6.2 IP addresses above).
This is the page that loads:
*The number in red represents the serial number of your SC-MB card (in this case 0000).
