SIRE XROOM, Руководство по эксплуатации и установке

Страница: 25 / 50

Fig. 13
- If necessary, use the marks on the installation template to determine the centre of the holes
Fig.12
- It is essential that the axis of the drilled hole is horizontal and 90° to the inner surface of the
circumferential wall.
- Be sure to observe the diameter of the drilled holes in the wall. Otherwise, there is a real risk of
incorrect installation and, consequently, poor functionality of the unit.
3.2.4. Preparation of Supply and Drain Piping
- The installation accessories, which are always supplied with the unit as mandatory accessories, are for
walls with the maximum thickness of 0.5 m.
- Extension of the piping for walls with a thickness greater than 0.5 m is solved in Section 3.2.4.1.
- Measure the total wall thickness with the thickness of the installation template through the drilled hole
(the thickness of the installation template itself is 2 mm).
- From box 2 – installation accessories, remove 1 pc “supply piping assembly with damper
Ø
125 mm,
(Xroom250
Ø
150 mm), length 500 mm” – position D.
- Transfer the measured length to the supply piping assembly with damper where the measurement starts
from the side where the damper and orientation blue point are located.
- From box 2 – installation accessories, remove “white plastic tube, length 500 mm” – position A.
- Transfer the measured length (wall thickness) to the other piece of plastic tube.
- Cut the supply pipe assembly with damper and the second pipe.
BE SURE TO KEEP THE
HOLE CENTRE
CORE DRILL – DRILL AXIS 90° WITH WALL!!!
1
2
4
5
SUPPLY BRANCH (UPPER PIPING)
3
6
EXTRACT BRANCH (LOWER PIPING)
25
Version 1 – GBR(23/06/2021) D-502-0152