SIRE XROOM, Руководство по эксплуатации и установке

Страница: 23 / 50

- If you carry out the installation into the wall with a thickness greater than 500 mm, get also thematerial:
o
Plastic air-conditioning piping with a length greater than the wall thickness:

Xroom 100 (XR1-010...) piping diameter 125 mm

Xroom 250 (XR1-025...) piping diameter 125 mm
2 pc
2 pc
o Direct coupling – insert

Xroom 100 (XR1-010...) piping diameter 125 mm

Xroom 250 (XR1-025...) piping diameter 125 mm
o
Aluminium air-conditioning tape or other one for the same purpose
2 pc
2 pc
1 pc
3.2.2. Fitting and Mounting the Installation Template with Mounting Pins
- Make sure that you have complied with all the principles necessary for correct installation specified in
this manual:
- Pull the installation template with pins upwards from box 1,
- Close the box with the remaining unit components and place it at a safe distance from the assembly site
to prevent its damage by dust from the construction work during the installation,
- Remove the mounting pins; if the mounting pins cannot be removed by hand, use a size 8 wrench,
- Save the mounting pins for future use
Fig.9
3.2.2.1. Fitting the installation template on the wall when using the construction module
- If you used a building module (XR1-xxx-DUCT-1) to build the wall, on which the unit will be located,
proceed as follows:
o
Remove the plugs from the construction module (cylinder) approx. 20 mm into the room
o
Insert the installation template through the circular holes in the template on the plugs removed
from the construction case
o
Continue the installation as per 3.2.2.3
3.2.2.2. Fitting the Installation Template on the Existing Wall
- Place the installation template at the desired location.
- Measure the required distances of the unit from the fixed surfaces while observing the minimum
installation clearances specified in Section 3.1.4.
- Continue the installation as per 3.2.2.3
3.2.2.3. Installation Template Mounting
- Use a spirit level to level the template,
o
If necessary, the top nuts for the mounting pins can be used to adjust the spirit level. Make sure the
level is correctly laid on the nuts.
- Mark all the mounting holes for installation of the template on the wall,
2
1
3
LOOSEN WITH
HAND OR KEY 8
AND REMOVE
4
23
Version 1 – GBR(23/06/2021) D-502-0152