Sinoboom GTJZ0612E, Руководство по обслуживанию

Страница: 73 / 94

MAINTENANCE PROCEDURES
GTJZ0612E&0812E&1012E&1212E Maintenance Manual 5-15 © Jul.2020
terminate the connection between the internal circuit
and the battery to avoid charging and damaging the
battery.
• Output short-circuit protection: When there is an
accidental output short circuit of the battery charger,
the battery charger will shut down the output
automatically to troubleshoot the problem. Then, the
battery charger will restart after a delay of 10
seconds.
• Charging indication: The yellow indicator lamp will
illuminate when charging, the green indicator lamp
will illuminate after charging and the red indicator
lamp will illuminate if the battery has a problem.
• Charging brake: All functions of the machine will not
operate when charging.
Use and Care of Lead-acid Battery
(maintenance-free)
The use and care requirements for lead-acid
maintenance-free batteries are as follows:
PREPARATION
• Before checking the fault, the operator must wear
safety equipment, including insulating gloves,
helmets and other necessary safety supplies and
multimeters.
• Inspect the battery system cabinet for problems
such as battery deformation, damage of the positive
and negative terminals, etc.
• Check and confirm the fault description and analyze
the cause.
CHARGING
• Do not use an external charger.
• Charge using the correct AC input voltage indicated
on the decal.
• Make sure the battery is connected before charging.
• Connect the battery charger to a grounded AC
circuit.
• Charge the battery every time after using.
CARE
• While wearing proper hand and face protection,
wipe the top and sides of the battery.
• Do not rinse or spray the battery pack with a water
hose.
• Be sure the cable connector is tight on the terminal.
• Do not leave the battery in a discharged state during
storage, as it will shorten the service life.
CAUTIONS
• Because there is a risk of high voltage, do not touch
non-insulated terminals or connectors.
• The battery terminal and related accessories
contain lead and lead components. Wash your
hands after handling them.
Use and Care of Lithium Battery
The requirements for the use and care of lithium
batteries are as follows:
PREPARATION
• Before checking the fault, the operator must wear
safety equipment, including insulating gloves, face
shields and other necessary safety supplies and
special tools such as multimeters, communication
tools (485 communication box or CAN) and
computers, etc.
• Inspect the battery system cabinet for problems
such as deformation of the cabinet, damage of the
positive and negative terminals, loose connection of
the communication navigation plug, etc.
• Check if the harness on the communication
navigation plug is misaligned.
• When the system is powered, the battery
information is read through 485 communication or
CAN communication.
• Check and confirm the fault description and analyze
the cause.
CAUTIONS
• In the driving process (traveling or lifting), if there is
no emergency, do not arbitrarily disconnect the key
to forcibly cut off the battery system main relay.
• When the display shows that the battery voltage is
too low, charge the battery as soon as possible to
prevent the battery from being over-discharged.
• After using the battery for a long period of time,
charge the battery as soon as possible before
leaving it for a long period of time to prevent the
battery from over-discharging due to
selfconsumption of the battery system.
• If there is heat, deformation, liquid leakage, odor or
smoke while using the battery, immediately stop
using the battery and place the battery in an open
place away from anyone.
• The battery is only suitable for this particular
product. Never use the battery with other
equipment.
• Do not use a wire to directly short-circuit the battery
output.
• Do not immerse the battery in water, acid, alkaline
or a salt solution and avoid rain.
• Do not use or store the battery in environments
such as corrosive, explosive and high-temperature
areas. Keep the battery out of areas with high heat
and exposure to fire or sun.