Sinoboom GTJZ0612E, Руководство по обслуживанию

Страница: 59 / 94

GTJZ0612E&0812E&1012E&1212E Maintenance Manual 5-1 © Jul.2020
5
MAINTENANCE PROCEDURES
Maintenance procedures must be
performed by qualified, trained and
competent personnel in a properly
equipped workshop.
Replace or repair damaged
components immediately. Do not
operate the machine with known
damaged components.
Be sure the machine is properly
maintained before operating it.
Before starting the machine:
• Read, understand and follow all
safety rules and instructions in
this manual.
• Read all procedures and
specifications completely.
• Unless otherwise specified,
perform all maintenance
procedures per the following:
– Park the machine on flat, level
and firm ground.
– Be sure the platform is fully
retracted.
– Turn the key switch to the
“OFF” position and remove the
key.
– Chock all wheels.
PLATFORM COMPONENTS
Removing the Platform Controller
ELECTRICAL SHOCK HAZARD
Be sure to disconnect the battery
from the machine and the charger
from the AC outlet before performing
this procedure. Contact with live
conductors could result in death or
serious injury.
NOTICE
Perform this procedure when the scissor arm has
been fully retracted.
1. Disconnect the external power supply. Turn the
emergency stop button on the platform controller
and ground controller to the OFF position.
2. Locate the cable connected to the bottom of the
platform controller.
3. Tag and disconnect the cable from the bottom of the
platform controller.
4. Remove the platform controller and mounting
bracket.
5. Move the platform controller and bracket from the
platform.
Removing the Platform
1. Remove the platform control box from the platform.
Refer to
Removing the Platform Controller, page
5-1
2. Remove the bolt in the slider at the fixed end of the
chute at the bottom of the platform.
Figure 5-1
3. Lift and push the platform to move the sliding block
to separate the platform.
4. Move the platform away.