SincoSald NOVATIG 403 DC PULSE, Инструкция по эксплуатации

Страница: 27 / 40

Pin Remote Plug Connection
Potentiometer UP/DOWN
Socket Pin
Function
Potentiometer Up/down
1 Not connected Not connected
2 Not connected Not connected
3
10k ohm (maximum) connection to 10k ohm
remote control potentiometer
Not connected
4
Wiper arm connection to 10k ohm remote
control potentiometer
Not connected
5
Zero ohm (minimum) connection to 10k
ohm remote control potentiometer
Not connected
6 Not connected The button of "UP" input
7 Not connected The button of "DOWN" input
8 Trigger Switch Input Trigger Switch Input
9 Trigger Switch Input Trigger Switch Input
10 Be shorted with 11 Not connected
11 Be shorted with 10 The button of "UP"& "DOWN" input
12 Not connected Not connected
Trigger
Switch
Short
Circuit
Remote
Amps
max
min
Trigger
Switch
Down Up
To synchronise a remote control to a machine,
follow these instructions
1. Ensure the welding power supply is switched off.
2. Press and hold the parameter select/adjust
knob on the front panel of the power supply
(2-4 seconds) while at the same time turning the
machine ON using the ON-OFF switch on the
back of the welding power supply.
3. When the display on the front panel of the power
supply is blank, release the control knob. Turn on
the remote control or foot pedal while at the same
time pressing any buttons on the remote control
panel or foot pedal, the digital meter on the front
panel of the welding power supply flick twice to
indicate the synchronization is successful and
6.5. REMOTE CONTROL CONFIGURATION
6.5.1. Wireless remote control Configuration
TIG series of welding machines can be configured to
communicate exclusively with wireless foot pedal or
remote control panel. This is done by a simple process
of synchronising the wireless remote control and
the machine frequencies. Each interface frequency
assigned is unique, so it is possible to use several
wireless control systems / machines in the same area
with no problems. The direct range of the wireless
control system is approximately 100m, this will be
affected by the physical location of the machine and
the remote control.
27 1.995.229 EN - Rev. 1.1
NOVATIG 403 DC PULSE