Sinclair MS-E48AIN, Руководство по обслуживанию

Страница: 26 / 100

Press this button to set up &down swing angle, which circularly changes as below:
This remote controller is universal. If any command , or is sent out, the unit will carry out the
command as
indicates the guide louver swings as:
7) I FEEL:
Press this button to turn on I FEEL function. The units automatically adjust temperature according to the
sensed temperature. Press this button again to cancel I FEEL function.
8)
Press this button to achieve the on and off of healthy and scavenging functions in operation status. Press this
button for the first time to start scavenging function; LCD displays“ ”. Press the button for the second time to
start healthy and scavenging functions simultaneously; LCD displays“ ” and “ ”. Press this button for the
third time to quit healthy and scavenging functions simultaneously. Press the button for the fourth time to start
healthy function; LCD display “ ”. Press this button again to repeat the operation above.
9) SLEEP:
◆
Press this button, can select Sleep 1 ( ), Sleep 2 ( ), Sleep 3 ( ) and cancel the Sleep, circulate
between these, after electrified, Sleep Cancel is defaulted.
◆
Sleep 1 is Sleep mode 1, in Cool or dry mode: sleep status after run for one hour, the main unit setting
temperature will increase 1
℃
, after 2 hours the setting temperature will increase 2
℃
, but the maximal setting
temperature is 30
℃
, then the unit will run at this setting temperature all along; In Heat mode: sleep status
after run for one hour, the setting temperature will decrease 1
℃
, after 2 hours the setting temperature will
decrease 2
℃
, but the minimal setting temperature is 16
℃
, then the unit will run at this setting temperature.
◆
Sleep 2 is sleep mode 2, that is air conditioner will run according to the presetting a group of sleep
temperature curve.
◆
Sleep 3- the sleep curve setting under Sleep mode by DIY:
①
Under Sleep 3 mode, press "Turbo" button for a long time, remote control enters into user individuation
sleep setting status, at this time, the time of remote control will display "1hour ", the setting temperature
"88" will display the corresponding temperature of last setting sleep curve and blink (The first entering
will display according to the initial curve setting value of original factory);
②
Adjust "+" and "-" button, could change the corresponding setting temperature, after adjusted, press
"Turbo" button for confirmation;
③
At this time, 1 hour will be automatically increased at the timer position on the remote control, (that are
"2 hours " or "3 hours " or "8 hours "), the place of setting temperature "88"will display the
corresponding temperature of last setting sleep curve and blink;
④
Repeat the above step (2)
～
(3) operation, until 8 hours temperature setting finished, sleep, curve
setting finished, at this time, the remote control will resume the original timer display; temperature
21