Simrad NSS evo3, Руководство по установке

Страница: 32 / 51

Adjust local interference reject
Interference from some onboard sources can interfere with the Broadband radar. One
symptom of this could be a large target on the screen that remains in the same relative
bearing even if the vessel changes direction.
Choose from Local interference rejection LOW, MED or HIGH. Default is LOW.
Restore radar to factory defaults
This option can be used to revert all user adjustments.
Video In configuration
Open the menu on the video panel to set up video.
Enable PAL or NTSC depending on the video output standard of the
selected camera.
You can optimize the video display by adjusting the video image
settings (brightness, saturation, etc.).
The settings are applied individually for each video source.
Mirror image may be applied where the camera is providing a rear
view, and the user wishes to see objects as they would appear in a
vehicle rear view mirror, i.e., on the same side as they actually are.
Autopilot setup
For setup and commissioning of autopilot computers, refer to the documentation included
with the autopilot computer.
Ú
Note:
The WheelKey can be used as a STBY key when configured for autopilot control. To
configure the WheelKey, refer to
"Configuring the WheelKey"
on page 24.
Fuel setup
The fuel utility monitors a vessel's fuel consumption. This information is totaled to indicate
trip and seasonal fuel usage, and is used to calculate fuel economy for display on instrument
pages and the data bar.
To use the utility, a Navico Fuel Flow sensor, or a NMEA 2000 engine adaptor cable/gateway
with Navico Fuel Data Storage device must be fitted to the vessel. Neither the Navico Fuel
Flow sensor, nor the Suzuki engine interface require the use of a separate Fuel Storage
device. Refer to the engine manufacturer or dealer for information on whether or not your
engine provides a data output, and what adaptor is available to connect to NMEA 2000.
Once the physical connection is made, ensure source selection is completed. Multiple engine
installations using Fuel Flow sensors, or Fuel Data Storage devices, require setup of related
engine location in the Device list. For general source selection information, refer to
"Data source
selection" on page 24.
Vessel setup
The Vessel setup dialog must be used to select the number of engines, the number of tanks
and vessel’s total fuel capacity across all tanks.
Software Setup | NSS evo3 Installation Manual
33