3
SimpliFire • SF-BI30-EB, SF-BI36-EB Service Manual • 2040-940 Rev. D • 5/20
Flame Screen Replacement
1. If necessary, place a drop cloth or other material on
the hearth or flooring to prevent scratching.
2. Remove front. Refer to Front Replacement section
for details.
3. Remove glass. Refer to Glass Replacement section
for details.
4. Remove log/grate assembly. Refer to Log/Grate
Assembly Replacement section for details.
5. Remove back refractory panel. Refer to Refractory
Replacement section for details.
6. Remove the flame screen panel by removing six
screws that attach it to the appliance chassis. See
Figure 14.
7 . Install the replacement flame screen panel, smooth
side facing out, and attach with six screws. See
Figure 14.
8
. If necessary, plug LED wire connection into back
side of ember bed. See Figure 3.
9. Re-install refractory.
10. Re-install log/grate assembly.
11. Re-install glass.
12. Re-install front.
LED Lighting Replacement
Note:
Kit includes all three LED light strip assemblies.
1. If necessary, place a drop cloth or other material on
the hearth or flooring to prevent scratching.
2. Remove front. Refer to Front Replacement section
for details.
3. Remove glass. Refer to Glass Replacement section
for details.
4. Remove log/grate assembly. Refer to Log/Grate
Assembly Replacement section for details.
5. Remove the two metal brackets in front of rear LED
strip. Remove four screws to remove metal parts.
See Figure 4. Take care when repairing model SF-
BI36-EB as the LED circuit is attached to the metal
bracket. See Figure 7.
6. Locate Lighting LED circuit input power source
connectors in rear of opening. Please note, when
repairing model SF-BI36-EB, the LED circuit is
attached to the metal bracket. See Figure 7. Unplug
the two connectors and jumper wire from the three
circuit boards. See Figure 6. If epoxy will not allow
separation of the two connectors, slide the pair of
connectors off the pins of the LED circuit board.
7. Using a pliers, compress each barbed clip along the
circuit board while lifting the board evenly to
disengage it from the clip. See Figure 5.
8. Remove all three lighting LED circuit boards.
9. Install replacement lighting LED circuit boards into
the appliance. Fully engage each barbed clip. See
Figure 6.
10. Connect all three lighting LED power source
connectors to the three LED circuit boards.
See
Figure 6.
11. Install metal brackets by attaching with four screws.
See Figure 4.
12. Re-install log/grate assembly.
13. Re-install glass.
14. Re-install front.
(FLAME-BI30-B, FLAME-BI36-B)
(LED-BI30-B, LED-BI36-B)
