5
SimpliFire • SF-BI30-EB, SF-BI36-EB Service Manual • 2040-940 Rev. D • 5/20
Remote Receiver Replacement
1. If necessary, place a drop cloth or other material on
the hearth or flooring to prevent scratching.
2. Remove front. Refer to Front Replacement section
for details.
3. Remove glass. Refer to Glass Replacement section
for details.
4. Remove log/grate assembly. Refer to Log/Grate
Assembly Replacement section for details.
5. Remove side and back refractory. Refer to
Refractory Replacement section for details.
6
. The remote receiver is positioned in the center of
the appliance behind the back refractory. See Figure
10. Disconnect the wiring harness from the top of the
receiver. See Figure 12.
7. Using a pliers, compress each barbed clip while lifting
the remote receiver board evenly to disengage it from
the clip. Carefully align the new remote receiver
board to the barbed clips and push in place.
8. Securely reconnect the wiring harness.
9. Re-install refractory panels.
10. Re-install log/grate assembly.
12. Re-install glass.
13. Re-install front.
Leveling Brackets Replacement
Install leveling brackets (2) by aligning them to the
preset holes on the top of the appliance. Use two
screws (ST4 x 8) per bracket to secure the appliance.
See Figure 19.
Plug-in Kit
To attach plug-in kit for 120V applications, follow the
steps below:
1. Remove the screws securing the junction box cover
plate on the upper right side of the appliance.
2. Gently pull cover plate away from unit and unplug
white connector.
3. Attach the white connector on the supplied plug-in kit.
4. Inspect all wire connections for any exposed wires.
5. Secure junction box cover plate.
6. Confirm the selector switch located behind the glass
on the ceiling of the unit is set to 120V.
(RECEIVER-ELECT)
(HRDW-BI)
(PLUGIN-ELECT-B)
