SimpliFire • SF-BI30-EB, SF-BI36-EB Service Manual • 2040-940 Rev. D • 5/20
4
Heater/Control Board Assembly
1. If necessary, place a drop cloth or other material on
the hearth or flooring to prevent scratching.
2. Remove front. Refer to Front Replacement section
for details.
3. Remove glass. Refer to Glass Replacement section
for details.
4
. Remove four thumb screws and metal angle bracket
from upper rear of appliance cavity. See Figure 8.
5. Remove four screws from upper face of appliance.
Take care to support the Blower/Heater Module while
the screws are removed. See Figure 9.
6. Remove the Blower/Heater Module by lifting back
edge slightly then pulling it straight back from the
appliance opening. This will reduce the likelihood of
damaging the brick panels.
7. Locate the seven electrical connectors on the right
side of the appliance cavity. Disconnect each of the
five connectors. See Figure 10.
8. Reconnect the seven connectors from the
replacement Blower/Heater module to the appliance.
See Figure 10.
9. Carefully align the replacement Blower/Heater
module horizontally with the opening of the appliance.
Install it straight into the opening so that the back
edge interlocks with the back wall of the appliance.
10. While supporting the Blower/Heater Module, install
the four screws across the upper face of the
appliance. See Figure 9.
11. Install the four thumb screws and angle metal
bracket in the upper rear of the appliance cavity.
See Figure 8.
12. Re-install glass.
13. Re-install front.
Rotisserie Motor and Rod
1. If necessary, place a drop cloth or other material on
the hearth or flooring to prevent scratching.
2. Remove front. Refer to Front Replacement section
for details.
3. Remove glass. Refer to Glass Replacement section
for details.
4. Remove log/grate assembly. Refer to Log/Grate
Assembly Replacement section for details.
5. Remove refractory. Refer to Refractory Replacement
section for details.
6. Remove Flame Screen. Refer to Flame Screen
Replacement section for details.
7 Disengage rotisserie rod from motor located in right
rear of cavity. Use hand to shift the reflector rod to
the left until the rubber coupler on the right end
disengages from the motor shaft. See Figure 15.
8. Remove metal bracket in right side of cavity to allow
access to the rotisserie motor and wiring
connections. Remove two screws to remove panel.
See Figure 16.
9. Remove three screws that attach motor mount
bracket to the appliance chassis. See Figure 17.
10. Remove the motor and bracket from the chassis until
the electrical connector is visible. See Figure 18.
11
. Disconnect the electrical connector to the motor. See
Figure 18.
12. Install the replacement motor on the bracket
.
13. Reconnect the electrical connector between the
motor and the appliance. See Figure 18.
14. Install the motor mount bracket to the chassis with
three screws. See Figure 17.
15. Install the replacement reflector rod. Install the left
end of the rod into the bushing in the left rear of the
cavity. Align the rubber coupler with the motor shaft.
Shift the rod to the right until the rubber coupler fully
engages the motor shift. See Figure 15.
16. Reinstall metal bracket in front of faux motor. Install
two screws to fasten the panel. See Figure 16.
17. Re-install flame screen.
18. Re-install log/grate assembly.
19. Re-install refractory.
20. Re-install glass.
21. Re-install front.
(HEATER-BI30-B, HEATER-BI36-B)
(ROTISS-BI30-EB, ROTISS-BI36-EB)
