3. Recessed grip ring
4. Inside thumb-turn
5. Battery replacement key
6. Locking disc with opening (identical on outside)
7. Outside thumb-turn
6.3.1.1 Removing the outside thumb-turn
Place the installation key on the outside thumb-turn in such a way that its
two teeth engage into the outside thumb-turn; if necessary, turn the
thumb-turn until both teeth lock into the locking disc.
NOTE
The installation tool must be placed flat on the inside front surface of the
thumb-turn to ensure that the tool can lock into the locking disc.
Hold the outside thumb-turn firmly and carefully turn the installation tool
about 30° in a clockwise direction (until you hear a click). Detach door
thumb-turn.
6.3.1.2 Fastening the digital cylinder into the lock
Turn the cam until it is vertical and pointing downwards. Insert the digital
locking cylinder through the lock in such a way that the inside thumb-turn
(see diagram above) is facing the inner side of the door. Fasten the cylinder
into the mortise lock with the fastening screw.
NOTE
You must not strike the thumb turns when installing the cylinder. Do not al-
low the cylinder to come into contact with oil, grease, paint or acids.
6.3.1.3 Fastening the outside thumb-turn
Replace the thumb-turn and turn in an anti-clockwise direction while
applying slight pressure until the outer thumb-turn grips into the indents in
the flange. Possibly place the thumb-turn in this position by pressing it
towards the profile cylinder housing.
NOTE
SmartIntego
Locking cylinder
(Manual)
6. Installation guide for 'SmartIntego'
18 / 44
