33
32
7
Troubleshooting and fault correction
Fault
Cause
Remedy
Gun drips
Component A
Material needle or nozzle dirty
Material needle or nozzle
damaged
Needle spring (item 13) not in
order, possibly broken
Material needle does not
agree with nozzle size
Adjusting screw (item 9) tur-
ned too far back
Clean
Replace, according to
5 Converting / repairing the
spray gun
Remove material needle
and replace spring
Make sure diameters are
the same
Slightly turn in the adju-
sting screw (clockwise)
Gun is dripping
(Component B)
Component B is damaged
Component B is leaky
Replace
Replace
Pulsating or
unsteady spray jet
Level in material tank too low
Material nozzle is loose or
damaged
Refill material (see
operating instructions of
system manufacturer)
Tighten
Gun keeps blo-
wing in off-position
Valve spring (Item 6.3) or
Valve shaft (Item 6.2) dama-
ged
Replace
8
Disposal
Waste spraying media and waste material from cleaning and servicing must be
disposed of in accordance with all applicable local and national regulations.
9
Technical data
Net weight:
470 g
Nozzle orifice comp. A:
1.2 / 2 mm ø
Nozzle orifice comp. B:
0.4 mm ø
Air Cap:
Round spray jet
Wide spray jet
Pressure ranges
intake air pressure:
max. 5 bar
material pressure:
max. 1 bar
recommended atomizer air pressure
ca. 1 - 2 bar
max. operating temperature:
43°C
Sound level
(measured at approx. 1 m
distance to the spray gun)
83 db (A)
Air consumption:
Atomizer air pressure
Round spray jet
in l/min.
Wide spray jet
in l/min.
1 bar
93
130
2 bar
155
210
3 bar
205
290
4 bar
260
360
5 bar
310
440
Right to effect technical changes reserved.
