SIMALFA G9 2K, Руководство по эксплуатации

Страница: 13 / 39

25 24
1 General
1.1
Model identification
Model: Two-component hand spray gun
Type: SIMALFA
®
G9 2K Wide jet V 11 815
SIMALFA
®
G9 2K Round jet V 11 816
Manufacturer: ALFA Klebstoffe AG
Vor Eiche 10
CH-8197 Rafz, Switzerland
Tel. +41 43 433 30 30
Fax +41 43 433 30 33
Email: info@alfa.swiss
www.simalfa.ch • www.alfa.swiss
1.2 Intended use
The manual spray gun G9 2K is used exclusively to process sprayable water-soluble
non-flammable two-component media. Because all material-carrying parts are manuf-
actured from stainless steel the model G9 2K is suited for the application with two-
component adhesives in the upholstery and foamed plastic industry.
Please contact ALFA Klebstoffe AG, if other materials shall be sprayed.
The sprayable materials may only be applied to work pieces or objects.
The temperature of the sprayed material must generally not exceed 43 °C.
Intended use also includes the reading and understanding of, as well as compliance
with all information and data in the operating instructions.
The information on the device signs or the details in the chapter on technical data
must be absolutely complied with and may not be exceeded. Overloading the device
must be ruled out.
If any particularities are noted during operation, the device must be shut down imme-
diately and ALFA Klebstoffe AG shall be contacted.
1.3 Unintended use
The spray gun must not be used for purposes other than those set forth in section
Intended use .
Any other use is considered inappropriate.
Inappropriate use includes, for example:
• spraying materials on persons and animals
• spraying liquid nitrogen.
• spraying of flammable materials
2 Technical description
The G9 2K is a spray gun model for the application of two-component dispersion
adhesives.
On site, the material is fed to the gun via a feed unit suitable for the adhesive.
The mixing ratio is determined by the selected nozzle sizes and by the supply pres-
sure.
3 Safety instructions
3.1 Identification of safety instructions
Warning
The pictogram and the urgency level “ Warning “ identify a possible danger to
persons.
Possible consequences: Slight to severe injuries.
Attention
The pictogram and the urgency level “ Attention “ identify a possible danger to
material assets.
Possible consequences: Damage to material assets.
Note
The pictogram and the urgency level “ Note “ identify additional information for the
safe and efficient operation of the spray gun.
3.2 General safety instructions
► Compliance with applicable accident prevention instructions and other acknow-
ledged health and safety regulations is mandatory.
► The users must be instructed in the safe handling of the spray gun.
► Use the spray gun only in well ventilated rooms. When spraying materials,
health hazards will increase.
► Always depressurize the air and material supply to the spray gun before
beginning with any maintenance and repair work - risk of injury.
► When spraying material do not hold hands or other parts of the body in front of
the pressurized nozzle of the spray gun. - Risk of injury.
Component A is ejected from the nozzle (1).
Component B is ejected through the nozzle integrated
into the air cap (2).
Both components are mixed in the spray jet outside
the gun and applied to the workpiece.
1
2