Sim2 CRYSTAL4-SH, Руководство пользователя

Страница: 28 / 64

CRYSTAL4-SH
User Guide
28
Switching On and Off
Switching On
I. Securely connect the power cord supplied and the signal cable. When
connected, the Power LED will turn red.
II. Turn on the projector by pressing button either on the back panel of the
projector or the “ | ” button on remote control. The power LED will now turn
blue. The startup screen will display in approximately 10 seconds.
III. Turn on and connect the source that you want to display on the screen
(computer, notebook, video player, etc.). The projector will detect the source
automatically. If not, read the following note.
Note: if you connect multiple sources at the same time, press the “SOURCE” button
on the back panel or the direct source keys on the remote control to switch between
inputs.
Switching Off
I. Press the button on the remote control or button on the back panel of
the projector one time. The following message will be displayed on the screen.
Press the button on the remote control, or the on the back panel again to
confirm, otherwise the message will disappear after 15 seconds. When you press
the button for the second time, the projector will shut down (the interval
between pressing has to be around one second to turn off the projector).
II. The cooling fans continue to operate for about 10 seconds for cooling cycle and
the Power LED will flash blue. When the Power LED lights solid red, the
projector has entered in standby mode. If you wish to turn the projector back
on, you must wait until the projector has completed the cooling cycle and has
entered standby mode. Once in standby mode, simply press the button on
the back panel or the “ | “ on the remote control to restart the projector.
III. Disconnect the power cord from the electrical outlet and the projector.
Warning: Do not turn on the projector immediately following a power off procedure.