Sim2 40-50-ST, Руководство пользователя и инструкция по установке

Страница: 27 / 175

MICO 40-50-ST
MiCO 50
24
setup menu
You can adjust the projector's settings to your preferences with the following options.
h/V Keystone
Correcting Trapezoidal Distortion and Adjusting Vertical Size of the picture:
This function allows for Keystone correction.
note
When the image is projected either from
•
top or from bottom
toward the screen at an angle, the image becomes distorted
trapezoidally. The function for correcting trapezoidal distortion is
called Keystone Correction.
select “h Keystone” or “V Keystone” in the setup 1 .
Selection Description
H Keystone
Horizontally adjusts the
keystone settings.
V Keystone
Vertically adjusts the
keystone settings.
Press“ 2
t
” or “
u
” to adjust the keystone
correction.
note
Since the trapezoidal distortion of the
•
image can be corrected up to various
angles, the actual screen can be
diagonally set up to that angle as well.
Straight lines or the edges of images may
•
appear jagged while adjusting the image.
Display Mode
These functions allow you to increase the brightness of the
projector.
note
Although noise is increased when “Display
•
Mode” is set to “Overlap”, brightness
increases by 20%.
“Display Mode” mode is factory preset to
•
“Normal”.
Status Brightness
Normal 80%
Overlap 100%
* “V-SIZE” is not displayed
when the value of
“KEYSTONE” is “0”.
Vertical Keystone Correction
Horizontal Keystone Correction
Compresses
upper side.
Compresses
lower side.
English
MiCO 50
25
Test Pattern
Select to display test patterns.
sync Threshold
This function is only available on Component input.
The projector is compatible with SDTV(480i and 576i), EDTV(480p and 576p), and HDTV(720p,1080i and 1080p) video
signals. If a hardware device, such a DVD player, is not syncing properly with the projector, adjust this option to help it to
sync when connected to the projector.
Auto Power Off
When an input signal is not detected and you don't press any input button on keypad or remote for more than 15
minutes, the projector will automatically turn off if set to “ON”.
Auto Power OFF function will be disabled when it is set to “OFF”.
note
When the Auto Power OFF function is set to “ON”, 5 minutes before the power turns off, the
•
message “Power OFF in 5 min.” will appear on the screen to indicate the remaining minutes.
source select
Used to select the input source automatically when there is no signal in the current input.
Source Select
Auto
Manual
note
If you select "Auto", then the input source is selected automatically.
•
high Altitude Mode
When it selected in ON, all the fan in the projector will be running in high speed mode.
lens shift
The function allows you to adjust the height and width of the projected image within the shift range of the lens.
initial settings
This process will set all the items to factory default settings.