Sim2 40-50-ST, Руководство пользователя и инструкция по установке

Страница: 19 / 175

MICO 40-50-ST
MiCO 50
16
Projection from behind the screen
Projecting a Reversed/inverted image
Place a translucent screen between the projector and the audience.
n
Reverse the image by setting “Floor Rear” for “Orientation” in the
n
“Image” menu.
Projection using a mirror
Place a mirror (normal flat type) in front of the lens.
n
Reverse the image by setting “Floor Rear” for “Orientation” in the
n
“Image” menu, when the mirror is placed on the side where the
audience is.
info
When using a mirror, be sure to carefully position
•
both the projector and the mirror so that the light
does not shine into the eyes of the audience.
Ceiling-mount setup
It is recommended that you use the optional ceiling-mount bracket
n
for this installation.
Before mounting the projector, contact your nearest Authorized
n
Service Center or Dealer to obtain the recommended ceiling-
mount bracket (sold separately).
Be sure to adjust the position of the projector to match the
n
distance (Z) from the lens center position to the lower edge of the
image, when mounting the projector on the ceiling.
Invert the image by setting “Ceiling” for “Orientation” in the “Image”
n
menu.
When using the default setting.
q
On-screen Display
The image is reversed.
When using the default setting.
q
On-screen Display
The image is reversed.
When using the default setting.
q
On-screen Display
The image is reversed.
English
MiCO 50
17
Basic Operation 3.
image Projection
Basic Procedure
Connect the required external equipment to the projector
before operating the following procedures.
info
The language preset at the factory is
•
English.
If you want to change the on-screen display
to another language, reset the language
according to the procedure on page 18.
Plug the power cord into the wall outlet. Press 1
the power switch to turn on the projector.
Press 0 on the remote control or
2 on the
keypad of the projector.
The power indicator illuminates blue, and the projector
•
enters power on mode.
note
The power indicator illuminates,
•
indicating the status of the LED.
Red:
The power is ready.
Blue: The image is displayed
Press 0 on the remote control to turn on the
•
“Source” selection menu when in normal
operation.
Press the source button on the projector to select 3
the inPUT mode.
KEY 1 Selects the source Composite.
KEY 2 Selects the source S-Video.
KEY 3 Selects the source Component.
KEY 4 Selects the source Graphics RGB.
KEY 5 Selects the source HDMI 1.
KEY 6 Selects the source HDMI 2.
KEY 7 Selects the source SCART
note
When a signal is not received,
•
“NO SIGNAL” will be displayed.
Set SCART enabled before
•
selecting the SCART input.
Press 4 on the remote control or on the projector to turn off the projector.
ESC SOURCE MENU
p
,
q
,
t
,
u
buttons
Power
MEnU
EsC
source
Remote control sensor
Red lED
Blue lED
LIGHT
F1
ZOOM
FOCUS
F2
EsC button
MEnU +/- button
Power button
ESC SOURCE MENU
p
,
q
,
t
,
u
buttons
Keys 1-7
selects the sources
directly.
1 Composite
2 s-ViDEO
3 COMPOnEnT
4 gRAPhiCs RgB
5 hDMi 1
6 hDMi 2
7 sCART
source button