58
5. Take off lid
1
.
Note:
There are two lugs on the front
edge of the lid. Pull these forward
slightly, lifting lid
1
as you do so, lift it up
and then take it off.
6. Turn screw housing
9
anticlockwise and
remove it.
7. Remove screw
11
from screw housing
9
.
8. Take screw ring
10
off
screw
11
.
9. Take kneader
8
out of dough
compartment
6
.
10.Take toothed
sleeve
7
off
kneader
8
.
11. Take dough compartment
6
off motor
housing
3
.
6.2 Assemble appliance
1. Put dough compartment
6
in motor
housing
3
.
2. Push screw ring
10
onto
screw
11
. Make sure that
the screw ring engages
correctly.
3. Put screw
11
in screw housing
9
.
4. Push kneader
8
onto the shaft of
screw
11
.
Note:
The shaft of
screw
11
has a notch,
A
,
with the result that
kneader
8
only fits in one
position.
5. Push toothed sleeve
7
onto the shaft of
screw
11
.
Note:
The shaft of screw
11
has a
notch, with the result that toothed
sleeve
7
only fits in one position.
6. Push screw housing
9
assembled with
screw
11
and kneader
8
into dough
compartment
6
.
Note:
On the inside of
screw housing
9
is an
extension
B
which has to
face upwards when put in
so that screw housing
9
can be latched correctly.
7. Push screw housing
9
gently against
dough compartment
6
and latch it by
turning it clockwise until it engages.
8. Check that dough compartment
6
is
correctly located in motor housing
3
.
9. Hold lid
1
at an angle and guide it into
lid locator
2
.
10.Push lid
1
down until it is correctly
located on dough compartment
6
and
audibly engages.
Note:
The safety switch which allows
the appliance to operate is activated
only if the lid is correctly engaged.
A
B
RP89212 Pasta Maker LB5 Seite 58 Mittwoch, 29. Mai 2013 5:22 17
