8
GB
NOTE:
if the smoothie is too thick, add a lit-
tle mineral water, fruit juice, milk or yoghurt
to suit your taste.
1. Place the fruit pieces and any other in-
gredients into the blender jug
5
-
7
as
desired. Mind the marking
MAX
for
the maximum filling quantity.
2.
Figure A:
screw the required blade at-
tachment
8
/
9
onto the blender jug
5
-
7
.
Ensure that the blade attachment is tightly
screwed to the blender jug.
3.
Figure B:
turn the blender jug
5
-
7
around and place it on the base unit
1
.
The small noses
13
on the edge of the
blender jug fit into the recesses at the
head of the base unit
1
.
4. Connect the mains plug
4
with the wall
socket.
5. A slight clockwise turn of the blender
jug
5
-
7
switches the device on.
Let the device run for no more than
60
seconds.
6. A slight anticlockwise turn of the
blender jug
5
-
7
switches the device
off.
Wait until the blades of the attachment
8
/
9
have come to a complete stop.
7. Remove the blender jug
5
-
7
from the
base unit
1
and turn it around.
8. Unscrew the blade attachment
8
/
9
and ensure that the liquid drips into the
blender jug
5
-
7
.
9. Before using it again and if necessary,
rinse the blade attachment
8
/
9
briefly
under running water.
10. Disconnect the mains plug
4
from the
wall socket.
11. Clean the device as soon as possible
after use.
6.4 Chopping ice cubes
For chopping ice cubes the device should be
switched on and off in a pulsating manner.
• Switch the device on and off 4x for up
to 10 seconds each time.
6.5 Drink immediately
•
Figure C:
in order to drink the fresh
smoothie directly from the blender jug
5
-
7
, screw a To-Go lid or the keep-fresh
lid
10
on the filled blender jug
5
-
7
. If
need open the drinking closure
12
and
drink from the opening for drink-
ing
11
. After you have closed the
drinking closure
12
the opening for
drinking
11
and blender jug
5
-
7
are
tightly closed. You can also enjoy your
smoothie “to go” when you are out
and about.
6.6 Storage
•
Figure C:
smoothies are intended to be
consumed as soon as possible. Then, it
is best to put the smoothie in the refrig-
erator. Use the keep-fresh lid
10
for this
purpose.
6.7 Overheating protection
The device has an overheating protection
system. If the device has been in operation
for too long thus causing the device to be-
come too hot, it automatically switches off.
• In this case, pull out the mains plug and
allow the device to cool.
• You may then put the device back into
operation.
__326494_Nutrition Mixer_B7.book Seite 8 Montag, 15. Juli 2019 12:15 12
