36 GB/IE
Getting started
Before proceeding with camera installation, we
advice to establish the connection with the router
first . Before installing the product in a desired
location, check the connection to verify whether
no electromagnetic disturbances exist in the area .
1. Installing the microSD card
(not included)
If you intend to record videos, install a microSD
memory card before mounting the camera .
Open the cover
2
.
Push in the microSD card against the spring of
the microSD card holder
3
, pins down, until
it locks in place .
Removing the microSD card: First gently push
the card in and then pull it out .
NOTE:
During operation, keep the cover
2
closed at all times or water might enter the
product .
NOTE:
We recommend to use a Class 10
rated microSD card or higher . A low speed card
can be damaged during high speed FHD (full
high definition) recording .
2. Installing the camera
NOTE:
For installation and alignment of the
camera all laws of the country of usage have
to be observed .
NOTE:
Cordless systems are exposed to
interference of telephones, microwaves, as well
as other electronic devices operating in the
2 .4 GHz range . Maintain a minimum distance
of 3 metres from those devices during installation
and operation .
NOTE:
Install the camera at a height and
position at which it cannot be reached without
aid . Proceed likewise with the Ethernet cable .
It is suggested to install the camera at least
2 .5 metres above the ground (Fig . C1) .
Stick the wall mounting template
18
on the
wall, eave or ceiling using duct tape (not
provided) in the desired mounting position .
Drill 4 mounting holes (Ø 6 mm, 1/4”)
(Fig . D1) . Drill 1 hole (Ø 16 mm, 5/8”) in the
wall for use as a cable guide (Fig . D2) .
Insert the wall plugs
20
into the mounting
holes (Fig . D3) .
Pull the camera connection cable
10
through
the cable hole .
Use sealing compound (e .g . silicone, not
provided) to seal the cable hole .
Place the wall mounting bracket
11
against
the wall .
Fix the wall mounting bracket
11
to the
mounting surface using the screws
19
and the
hex key
22
(Fig . E) .
Mark the area under surveillance with the
provided Under surveillance sticker
23
.
