Silvercrest 360253 2010, Руководство по эксплуатации

Страница: 78 / 411

78 - English
10.3. Changing the program
You can only change the program if the appliance has been operating for a short time. If
the appliance has already been running for a longer time, the detergent and water must
be replenished and the required program must be restarted.

Press the button (13) to interrupt the program.

Press the P button (17) for approx. 3 seconds until the appliance switches to standby
mode.

Then select another program: To do so, press the program selection button P several
times until the operating light(s) for the required program light(s) up.

Press the button (13) again to start the program.
The program starts after approx. 10 seconds.
10.4. Opening during operation
CAUTION!
Risk of burning!
Hot water/hot steam can escape and cause burns if the
door is opened while a program is running.

Do not open the dishwasher door fully straight away
– instead wait for about 3 seconds until the spray arm
stops rotating and then open the door completely.
The door can be opened while a program is running, allowing more dishes to be load-
ed or others to be removed. This is only efficient if the program has only been running for a
short time, as otherwise the newly loaded dishes might no longer be fully cleaned.

While the program is running, press the button (13). Wait about 3 seconds until the
spray arm stops rotating and then open the door.

Load the additional dishes and/or remove items.

Close the door again fully. Press the button (13) again to continue the program.
The program continues after approx. 10 seconds.