Shenzhen Santone SilverCon
Email: [email protected]
Web: www.silver-con.com
Page: 8
SCW001 User Manual
Caution:
Do not press Reset unless you want to clear the current settings. The Reset button is in a small circular hole
on the rear panel. If you want to restore the default settings, please press Reset gently for 3-6 seconds with
a fine needle inserted into the hole and then release the button. The system reboots and restores to the
factory default settings.
The power specification is 12V, 500 mA. If the power adapter does not match the specification, the device
may be damaged.
3.3 Hardware Installation
3.3.1 System Requirements
Before installing the device, please ensure that the following items are ready:
•
At least one Ethernet RJ45 cable (10Base-T/100Base-T)
•
One wireless router
•
A PC is already installed with the TCP/IP protocol and the PC can access the Internet.
3.3.2 Before You Begin
Before you install the device, please pay attention to the following items:
•
When the device is connected to a computer, hub, router or switch, the Ethernet cable should be less
than 100 meters.
•
Do not place this device on an unstable surface or support. Do not put this device on the ground.
•
Keep the device clean. Avoid the device from direct sunshine. Avoid any metal in the device.
• Place the device in the center of the area, and try to optimize the wireless coverage.
3.3.3 Connecting the Device
To connect the device, do as follows:
1. Connect one end of the RJ45 cable to the LAN interface of the wireless router.
2. Connect the other end of the RJ45 cable to your PC.
3. Connect the power adapter to the power socket of the wireless router.
3.4 Operation Range
The operation range of the wireless router depends on the actual environment. The path and effect of
signal transmission vary according to the deployment in a house or an office. For example, the outdoor
straight transmission distance for a certain device can be 300 meters and the indoor transmission distance
can be 100 meters.
3.5 Roaming
