SILENT KNIGHT 9500, Инструкция по установке и эксплуатации

Страница: 34 / 162

Installation
151059 3-19
3.11.3 Master/Slave Printer Configuration
Figure 3-18 illustrates the Master/Slave Printer configuration.
Figure 3-18 Master/Slave Printer Configuration
3.11.3.1 Master/Salve Printer Programming
Before attempting to program the master/slave printer, verify that all SBUS connections have
been made as described in 3.11.3. You will program the master receiver first, then program
each salve receiver.
To program the receivers for master/slave printer:
1. Power up the Master Receiver and allow the Line Cards to be initialized.
2. From the “Installer/Program Menu/General Options” display, select “1 Operation Mode”
and configure for “Automatic.”
3. From the “3 Communications” display, select “1 Port Functions” and configure COM1 for
“Automation” and parallel port for “Auto Bkp Prn.”
4. From “4 System Options” select “MstrPrn” and set appropriate “Rcvr ID.”
5. From “6 Slave List” enter a unique Slave number for each slave receiver.
6. Exit the programming mode and cycle power on the Master Receiver for the new settings
to take effect. You are done programming the Master Receiver.
7. Power up the Slave Receiver and allow the Line Cards to be initialized.
8. From the “Installer/Program Menu/General Options” display, select “1 Operation Mode”
and configure for “Automatic.”
9. From the “3 Communications” display, select “1 Port Functions” and configure COM1 for
“Automation.”
Limit to One Master and Seven Slaves Receivers
Standard RJ-11 Phone Cable