SILENT KNIGHT 9500, Инструкция по установке и эксплуатации

Страница: 121 / 162

Model 9500 Central Station Receiver Installation/Operation Manual
5-56 151059
Table 5-15: ITI Options Menu Items
ITI Options
Menu
Choice Valid Entry Comments
ITI SCode Menu
Default SCode 00000 to 99999 This set the default security code for this
line card. Additional security codes can be
added to the SCode table (see below).
Add Acct/SCode
(up to 20 entries)
Enter control panel 5-
digit account No. 00000 to 99999 Enter the 5-digit account number of the
ITI control panel that the receiver will be
looking for on this line card.
Set or Clear Security
Code. Clear
or
Clear old security code and set to default
security code. (See Default SCode above.)
Set If set is chosen an additional menu will
appear that allows you to enter the security
code you wish to set the panel to.
Security Code 00000 to 99999
(Appears only if
Set is previously
chosen)
Note:
If the security code entered here
is not presently in the SCode table (see be-
low), it will automatically be entered once
the line card has successfully communicat-
ed with that account.
Edit Acct/SCode 1 to 20 Same as Add
Acct/SCode Edit an account previously programmed
into Add Acct/SCode table.
Clear Acct/SCode 1 to 20 Remove an account that was previously
programmed into Add Acct/SCode table.
Add SCode Table
(up to 20) 00000 to 99999 Adds a new security code to the security
code table.
Clear Scode Table 1 to 20 Removes an security code from the SCode
table.
Date/Time Flag
Requested The date and time programmed into an ITI
control panel will only be updated by the
receiver if the control panel requests it.
Always The date and time programmed into an ITI
control panel will be updated by the
receiver automatically every time the
control panel calls into the receiver.
ITI 300 Baud Yes If enabled, the receiver will attempt to
negotiate 300 baud communication with
ITI panels that support 300 baud
communication. See 5.5.2.8 for
programming steps.
No
Audio Mode
Instant
ITI controls that have listen in initialized
will preform listen in instantly when the
control calls the central station.
One Ring
ITI controls that have listen in initialized
will preform listen in after one ring when
the control is called, after the control calls
the central station.
Dial Back
ITI controls that have listen in initialized
will call a programmed phone number
after the control calls the central station.