Silca Twister II NA, Руководство по эксплуатации

Страница: 18 / 24

Operating manual
Twister II NA
Copyright Silca S.p.A. 2015
14
Cutting the edge
If cuts are to be made on the edge, place the key in a vertical position.
Fig. 14
7.3 CUTTING LASER (SIDEWINDER ) TYPE KEYS
NOTE: before attempting to cut laser (sidewinder) type keys, deactivate the spring system for dimple
keys using knob (O ).
1) Install and calibrate the cutter and tracer (see section 6.2).
2) Gauge and clamp the pattern key into the left side clamp using the shoulder stop or tip stop position as described
earlier.
3) Using lever (I) lower the Z-axis until the tracer rests lightly on a CUT portion of the pattern key.
4) While maintaining light contact tighten the Z axis locking knob (R) to secure the Z-axis in this position.
5) Gauge and clamp the key blank into the right side clamp using the same shoulder or tip stop position as the
pattern key.
6) Once the key blank and pattern keys have been properly clamped, press the motor start switch (Q) to activate
the cutter motor.
7) Determine the starting point for your cut (see Fig. 15).
8) Using lever (C), trace the pattern key while moving the cutter into the the key blank.
NOTE: REMOVE THE TIP STOP BAR PRIOR TO ATTEMPTING TO CUT THE KEY!
Fig. 15