Silca Ilco Orion SMARTY 2000, Руководство по эксплуатации

Страница: 13 / 24

Operating manual - English SMARTY 2000
13
5 MACHINE INSTALLATION AND PREPARATION
The SMARTY 2000 key-cutting machine can be installed by the purchaser and does not require any
special skills.
However, some checks and preparation for use need to be carried out by the operator.
5.1 Checking for damage
The SMARTY 2000 key-cutting machine is solid and compact and will not normally damage if transport,
unpacking and installation have all been carried out according to the instructions in this manual.
However, it is always advisable to check that the machine has not suffered any damage.
5.2 Environmental conditions
To ensure that the best use is made of the SMARTY 2000 key-cutting machine, certain parameters
must be borne in mind:
-
damp, badly ventilated sites should be avoided.
- The ideal conditions for the machine are:
- temperature: between 0 and 40°C;
- relative humidity: 60% circa
5.3 Positioning
Place the key-cutting machine on a horizontal surface, solid enough to take the weight (23 Kg). To
facilitate operation and maintenance, install the machine with a space of at least 300 mm on all sides
(fig.5).
Ensure that the machine stands perfectly balanced on the four feet. Vibration is avoided when the
machine is properly set on the horizontal plane.
ATTENTION: ensure that the machine voltage is the same as that of the mains, which must be properly
earthed and provided with a differential switch.
Fig. 5
5.4 Description of work station
The key-cutting machine needs only one operator, who has the following controls at his/her disposal:
• Safety device (X) (standard with 230V key-cutting machines).
• Motor start switch (D1) (fig.4, page 8), placed on the left-hand side of the machine;
illuminated to show that the machine is live.
• Carriage movement lever (A).
• Carriage handle lever (G1).
• Gauge knob (B).
300 mm
30
0 m
m
300 m
m