Silca Ilco Orion SMARTY 2000, Руководство по эксплуатации

Страница: 9 / 24

Operating manual - English SMARTY 2000
9
3 MACHINE DESCRIPTION
SMARTY 2000 is a professional cutting machine for flat keys used with cylinder, car locks and cruciform
keys. The main parts of the machine are described below:
Safety device
The device is connected to a power plug with a differential switch, power the key-cutting machine by
pressing the switch (X1).
The warning light (X2) illuminates to indicate voltage in the plug (X3).
ATTENTION: switch (X1) is electromagnetic, in the event of a power failure it goes out automatically. When
electricity is restored it must be reset manually to power the machine again by means of the plug
(X3).
Motor start-up switch
The motor start-up switch (D1) is placed on the left-hand side of the SMARTY 2000 key-cutting
machine.
ATTENTION: the illuminated switch is always lit to show that the key-cutting machine is live.
Motor and transmission unit
The motor has belt transmission. The transmission unit is placed on the left of the motor and activates
the brush (E) and cutting tool (F). These components are protected by three covers:
-
brush cover (E1),
- cutting tool cover (F1).
Clamp carriage
The clamp carriage (G) consisting of two clamps (H), is fitted to the horizontal movement carriage,
controlled by lever (A) and is provided with a handle (G1).
Cutting unit
The cutting unit contains the actual working parts of the SMARTY 2000 key-cutting machine, which
operate together to cut and finish keys "read" from the originals.
The working parts are described below:
• Brush
The brush (E) is used to eliminate burrs from the cuts and is made of non-abrasive material.
• Cutting Tool
The cutting tool (F) is the part of the SMARTY 2000 used for cutting key blanks. The cutting tool is in
TiAl super rapid steel and is protected by a special cover (F1) to ensure safe operation.
• Tracer point
The tracer point (C), used for reading the profile of the key to be copied, is housed on the right-hand
side of the machine base. Assures regulation of the depth.
• Clamps
The clamps (H) have two sides (fig. 9 - pag. 14), which rotate to allow the key to be perfectly secured
on its back or in profile.
• Clamp knobs
The clamps are locked by two anatomical knobs (H1) which ensure perfect grip on the keys with only
slight locking pressure.
• Calibration tabs
The clamps have two gauge tabs, with which to adjust key alignment.